Keithley 2601B Reference Manual page 725

Series 2600B System SourceMeter® Instrument Reference Manual
Error summary
Error number
2204
2205
2206
2207
2211
2212
2213
2214
2215
2216
2217
2218
2219
2220
2221
2222
2223
2400
2401
2402
2403
2404
2405
2406
2407
2408
2409
2410
2411
2412
2413
2414
2415
2416
2417
2418
2419
2420
2500
4900
4903
4904
4905
4906
5001
5003
5004
5005
5007
5008
5009
2600BS-901-01 Rev. B / May 2013
Error level Error Message
RECOVERABLE Directory not found
RECOVERABLE File not found
RECOVERABLE Cannot read current working directory
RECOVERABLE Cannot change directory
RECOVERABLE File system error
RECOVERABLE File system command not supported
RECOVERABLE Too many open files
RECOVERABLE File access denied
RECOVERABLE Invalid file handle
RECOVERABLE Invalid drive
RECOVERABLE File system busy
RECOVERABLE Disk full
RECOVERABLE File corrupt
RECOVERABLE File already exists
RECOVERABLE File seek error
RECOVERABLE End-of-file error
RECOVERABLE Directory not empty
RECOVERABLE Invalid specified connection
RECOVERABLE Invalid timeout seconds (.001 to 30)
RECOVERABLE TSPnet remote error: XXX
RECOVERABLE TSPnet failure
RECOVERABLE TSPnet read failure
RECOVERABLE TSPnet read failure, aborted
RECOVERABLE TSPnet read failure, timeout
RECOVERABLE TSPnet write failure
RECOVERABLE TSPnet write failure, aborted
RECOVERABLE TSPnet write failure, timeout
RECOVERABLE TSPnet max connections reached
RECOVERABLE TSPnet connection failed
RECOVERABLE TSPnet invalid termination
RECOVERABLE TSPnet invalid reading buffer table
RECOVERABLE TSPnet invalid reading buffer index range
RECOVERABLE TSPnet feature only supported on TSP connections
RECOVERABLE TSPnet must specify both port and init
RECOVERABLE TSPnet disconnected by other side
RECOVERABLE TSPnet read input buffer overflow
RECOVERABLE Invalid format specifier
RECOVERABLE Termination locked while using TSP connection
RECOVERABLE Average delay must be at least NNN seconds
RECOVERABLE Reading buffer index NN is invalid
RECOVERABLE Reading buffer expired
SERIOUS ICX parameter count mismatch, (XXX Line #NNNN)
SERIOUS ICX parameter invalid value, (XXX Line #NNNN)
SERIOUS ICX invalid function id, (XXX Line #NNNN)
FATAL SMU is unresponsive. Disconnect DUT and cycle power
SERIOUS Saved calibration constants corrupted
RECOVERABLE Operation conflicts with CALA sense mode
RECOVERABLE Value too big for range
RECOVERABLE Operation would exceed safe operating area of the instrument
RECOVERABLE Operation not permitted while OUTPUT is on
SERIOUS Unknown sourcing function
Section 8: Troubleshooting guide
8-5