Lan.config.ipaddress; Lan.config.method - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual

lan.config.ipaddress

This attribute specifies the LAN IP address.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
ipAddress = lan.config.ipaddress
lan.config.ipaddress = ipAddress
ipAddress
Details
This attribute specifies the LAN IP address to use when the LAN is configured using the manual configuration
method. This setting is ignored when DLLA or DHCP is used.
This attribute does not indicate the actual setting that is presently in effect. Use the lan.status.ipaddress
attribute to determine the present operating state of the LAN.
Example
ipaddress = lan.config.ipaddress
Also see
lan.restoredefaults()
lan.status.ipaddress

lan.config.method

This attribute contains the LAN settings configuration method.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
method = lan.config.method
lan.config.method = method
method
Details
This attribute controls how the LAN IP address, subnet mask, default gateway address, and DNS server
addresses are determined.
When method is lan.AUTO, the instrument first attempts to configure the LAN settings using dynamic host
configuration protocol (DHCP). If DHCP fails, it tries dynamic link local addressing (DLLA). If DLLA fails, it uses
the manually specified settings.
When method is lan.MANUAL, only the manually specified settings are used. Neither DHCP nor DLLA are
attempted.
2600BS-901-01 Rev. B / May 2013
Affected by
LAN restore defaults
LAN IP address; must be a string specifying the IP address in dotted decimal
notation
(on page 7-121)
(on page 7-124)
Affected by
LAN restore defaults
The method for configuring LAN settings; it can be one of the following
values:
0 or lan.AUTO: Selects automatic sequencing of configuration methods
1 or lan.MANUAL: Use only manually specified configuration settings
Section 7: TSP command reference
Where saved Default value
Nonvolatile memory "192.168.0.2"
Retrieves the presently set LAN IP address.
Where saved Default value
Nonvolatile memory 0 (lan.AUTO)
7-117