Lan.reset(); Lan.restoredefaults() - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual

lan.reset()

This function resets the LAN interface.
Type TSP-Link accessible
Function Yes
Usage
lan.reset()
Details
This function resets the LAN interface. It performs the commands lan.restoredefaults() and
lan.applysettings().
Also see
lan.applysettings()

lan.restoredefaults()

lan.restoredefaults()
This function resets LAN settings to default values.
Type TSP-Link accessible
Function Yes
Usage
lan.restoredefaults()
Details
The settings that are restored are shown in the following table.
Settings that are restored to default
Attribute
lan.autoconnect
lan.config.dns.address[N]
lan.config.dns.domain
lan.config.dns.dynamic
lan.config.dns.hostname
lan.config.dns.verify
lan.config.duplex
lan.config.gateway
lan.config.ipaddress
lan.config.method
lan.config.speed
lan.config.subnetmask
lan.linktimeout
lan.lxidomain
lan.nagle
lan.timedwait
This command is run when lan.reset() is sent.
2600BS-901-01 Rev. B / May 2013
Affected by
(on page 7-111)
(on page 7-121)
Affected by
Default setting
lan.ENABLE
"0.0.0.0"
""
lan.ENABLE
""
lan.ENABLE
lan.FULL
"0.0.0.0"
"0.0.0.0"
lan.AUTO
100
"255.255.255.0"
20 (seconds)
0
lan.ENABLE
20 (seconds)
Section 7: TSP command reference
Where saved Default value
Where saved Default value
7-121