Gpib; Instrument Identification - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual
File descriptors cannot be passed between nodes in a TSP-Link
fileVar::read(), and fileVar::write commands are not accessible to the TSP-Link system.
However, the default input and output files mentioned above allow for the execution of many file I/O
operations without any reference to a file descriptor.
fileVar:close()
fileVar:flush()
fileVar:read()
fileVar:seek()
fileVar:write()
fs.chdir()
fs.cwd() (on page 7-95)
fs.is_dir()
fs.is_file()
fs.mkdir()
fs.readdir()
fs.rmdir()
io.close()
io.flush()
io.input()
io.open()
io.output()
io.read() (on page 7-109)
io.type() (on page 7-110)
io.write()
os.remove()
os.rename()
The following standard I/O commands are not supported at this time:
File
•
fileVar:lines()
•
fileVar:setvbuf()

GPIB

This attribute stores the GPIB address.
gpib.address

Instrument identification

These commands store strings that describe the instrument.
localnode.description
localnode.model
localnode.revision
localnode.serialno
2600BS-901-01 Rev. B / May 2013
(on page 7-89)
(on page 7-89)
(on page 7-90)
(on page 7-91)
(on page 7-91)
(on page 7-95)
(on page 7-95)
(on page 7-96)
(on page 7-96)
(on page 7-97)
(on page 7-97)
(on page 7-106)
(on page 7-107)
(on page 7-108)
(on page 7-108)
(on page 7-109)
(on page 7-111)
(on page 7-150)
(on page 7-151)
(on page 7-100)
(on page 7-138)
(on page 7-140)
(on page 7-143)
(on page 7-144)
I/O
•
io.lines()
•
io.popen()
Section 5: Introduction to TSP operation
®
system, so the io.open(),
5-7