Status.questionable.calibration - Keithley 2601B Reference Manual

Section 7: TSP command reference

status.questionable.calibration.*

This attribute contains the questionable status calibration summary register set.
Type TSP-Link accessible
Attribute - -
.condition (R) Yes
.enable (RW) Yes
.event (R) Yes
.ntr (RW) Yes
.ptr (RW) Yes
Usage
questionableRegister = status.questionable.calibration.condition
questionableRegister = status.questionable.calibration.enable
questionableRegister = status.questionable.calibration.event
questionableRegister = status.questionable.calibration.ntr
questionableRegister = status.questionable.calibration.ptr
status.questionable.calibration.enable = questionableRegister
status.questionable.calibration.ntr = questionableRegister
status.questionable.calibration.ptr = questionableRegister
questionableRegister
Details
These attributes are used to read or write to the questionable status calibration summary registers. Reading a
status register returns a value. The binary equivalent of the returned value indicates which register bits are set.
The least significant bit of the binary number is bit B0, and the most significant bit is bit B15.
For information about .condition, .enable, .event, .ntr, and .ptr registers, refer to
page E-1) and
the following table.
Bit Value
B0 Not used
B1 status.questionable.calibration.SMUA
B2
status.questionable.calibration.SMUB
B3-B15 Not used
7-306
Affected by
- -
Not applicable
Status reset
Status reset
Status reset
Status reset
The status of the questionable status calibration summary register; a zero
(0) indicates no bits set (also send 0 to clear all bits); other values indicate
various bit settings
Enable and transition registers
Series 2600B System SourceMeter® Instrument Reference Manual
Where saved
- -
Not saved
Not saved
Not saved
Not saved
Not saved
(on page E-19). The individual bits of this register are defined in
Description
Not applicable.
Set bit indicates that the SMU A calibration
constants stored in nonvolatile memory were
corrupted and could not be loaded when the
instrument powered up.
Bit B1 decimal value: 2
Binary value: 0000 0010
This bit is only available on Models
2602B/2604B/2612B/2614B/2634B/2636B. Set bit
indicates that the SMU B calibration constants
stored in nonvolatile memory were corrupted and
could not be loaded when the instrument powered
up.
Bit B2 decimal value: 4
Binary value: 0000 0100
Not applicable.
Default value
- -
Not applicable
0
0
0
Models 2601B/2611B/2635B: 2 (All bits set)
Models
2602B/2604B/2612B/2614B/2634B/2636B: 6
(All bits set)
Status register set contents
2600BS-901-01 Rev. B / May 2013
(on