Trigger.blender[N].Wait() - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual

trigger.blender[N].wait()

This function waits for a blender trigger event to occur.
Type TSP-Link accessible
Function Yes
Usage
triggered = trigger.blender[N].wait(timeout)
triggered
N
timeout
Details
This function waits for an event blender trigger event. If one or more trigger events were detected since the last
time trigger.blender[N].wait() or trigger.blender[N].clear() was called, this function returns
immediately.
After detecting a trigger with this function, the event detector automatically resets and rearms. This is true
regardless of the number of events detected.
Example
digio.trigger[3].mode = digio.TRIG_FALLING
digio.trigger[5].mode = digio.TRIG_FALLING
trigger.blender[1].orenable = true
trigger.blender[1].stimulus[1] = digio.trigger[3].EVENT_ID
trigger.blender[1].stimulus[2] = digio.trigger[5].EVENT_ID
print(trigger.blender[1].wait(3))
Also see
trigger.blender[N].clear()
2600BS-901-01 Rev. B / May 2013
Affected by
Trigger detection indication for blender
The trigger blender (1 to 6) on which to wait
Maximum amount of time in seconds to wait for the trigger blender event
(on page 7-336)
Section 7: TSP command reference
Where saved Default value
Generate a trigger blender 1
event when a digital I/O
trigger happens either on
line 3 or 5.
Wait three seconds while
checking if trigger blender 1
event has occurred.
If the blender trigger event
has happened, then true is
output. If the trigger event
has not happened, then
false is output after the
timeout expires.
7-341