Serial.databits; Serial.flowcontrol; Serial.parity - Keithley 2601B Reference Manual

Section 7: TSP command reference

serial.databits

This attribute configures character width (data bits) for the RS-232 port.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
bits = serial.databits
serial.databits = bits
bits
Details
A new data width setting takes effect when the command to change it is processed.
Allow ample time for the command to be processed before attempting to communicate with the
instrument again. If possible, set the character width from one of the other command interfaces or
from the front panel.
The reset function has no effect on data bits.
Example
serial.databits = 8
Also see
RS-232 interface operation
serial.baud (on page 7-173)

serial.flowcontrol

serial.parity

(on page 7-175)
serial.flowcontrol
This attribute configures flow control for the RS-232 port.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
flow = serial.flowcontrol
serial.flowcontrol = flow
flow
7-174
Affected by
Not applicable
An integer representing the character width (7 or 8)
(on page 2-108)
(on page 7-174)
Affected by
Not applicable
A string representing flow control configuration; set to:
•
"none" or serial.FLOW_NONE (selects no flow control)
•
"hardware" or serial.FLOW_HARDWARE (selects hardware flow control)
Series 2600B System SourceMeter® Instrument Reference Manual
Where saved
Nonvolatile memory
Sets data width to 8.
Where saved
Nonvolatile memory
Default value
8
Default value
"none" (serial.FLOW_NONE)
2600BS-901-01 Rev. B / May 2013