Keithley 2601B Reference Manual page 119

Series 2600B System SourceMeter® Instrument Reference Manual Section 2: General operation
9. In the Virtual Instrument Name box, enter a name that you want to use to refer to the instrument.
10. Click Finish.
11. Click Cancel to close the Wizard.
12. Save the configuration. From the Configuration Utility, select File > Save.
13. In the Keithley Communicator, select File > Open Instrument to open the instrument you just
named.
Figure 47: Keithley Communicator Open Instrument
14. Click OK.
15. Send a command to the instrument and see if it responds.
If you have a full version of NI VISA on your system, you can run NI-MAX or the VISA Interactive
Utility. See their documentation for information.
If you have the Agilent IO Libraries on your system, you can run Agilent Connection Expert to check
out your USB instruments. See their documentation for information.
Additional USB information
This section provides further details and more advanced information about the USB bus and
test-and-measurement instruments.
2600BS-901-01 Rev. B / May 2013 2-95