Keithley 2601B Reference Manual page 804

Appendix D: Common commands
Unlike other commands, like those listed in
must be sent in a separate message.
The common commands cannot be used in scripts.
Mnemonic
*CLS
*ESE <mask>
*ESE?
*ESR?
*IDN?
*OPC
*OPC?
*RST
*SRE <mask>
*SRE?
*STB?
*TRG
*TST?
*WAI
D-2
Name
Clear status
Event enable command
Event enable query
Event status register query
Identification query
Operation complete command
Operation complete query
Reset command
Service request enable command Programs the Service Request Enable Register. For detailed
Service request enable query
Status byte query
Trigger command
Self-test query
Wait-to-continue command
Series 2600B System SourceMeter® Instrument Reference Manual
TSP commands (on page 7-7), each common command
Description
Clears all event registers and Error Queue. For detailed
information including status commands, see the
page 5-14, on page E-1).
Program the Standard Event Status Enable Register. For detailed
information including status commands, see the
page 5-14, on page E-1).
Read the Standard Event Status Enable Register. For detailed
information including status commands, see the
page 5-14, on page E-1).
Read/clear the Standard Event Enable Register. For detailed
information including status commands, see the
page 5-14, on page E-1).
Returns the manufacturer, model number, serial number, and
firmware revision levels of the unit. For detailed information, see
Identification query: *IDN?
Set the Operation Complete bit in the Standard Event Register
after all pending commands, including overlapped commands,
have completed. For detailed information, see
and query: *OPC and *OPC?
Places an ASCII "1" into the output queue when all selected
device operations have completed. For detailed information, see
Operation complete and query: *OPC and *OPC?
Returns the Series 2600B to default conditions. For detailed
information, see Reset: *RST
information including status commands, see the
page 5-14, on page E-1).
Reads the Service Request Enable Register. For detailed
information including status commands, see the
page 5-14, on page E-1).
Reads the status byte register. For detailed information including
status commands, see the
E-1).
Generates the trigger.EVENT_ID trigger event for use with the
trigger model. For detailed information, see
page D-4).
Returns a 0. For detailed information, see
(on page D-4).
Waits until all previous commands have completed. For detailed
information, see Wait-to-continue: *WAI
Status model
Status model
Status model
Status model
(on page D-3).
Operation complete
(on page D-4).
(on page D-4).
(on page D-4).
Status model
Status model
Status model (on page 5-14, on page
Trigger: *TRG
Self-test query: *TST?
(on page D-5).
2600BS-901-01 Rev. B / May 2013
(on
(on
(on
(on
(on
(on
(on