Tsplink.trigger[N].Reset() - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual
Details
Releases a trigger that was asserted with an indefinite pulse width. It also releases a trigger that was latched in
response to receiving a synchronous mode trigger.
Example
tsplink.trigger[3].release()
Also see
tsplink.trigger[N].assert()
tsplink.trigger[N].clear()
tsplink.trigger[N].mode
tsplink.trigger[N].overrun
tsplink.trigger[N].pulsewidth
tsplink.trigger[N].stimulus
tsplink.trigger[N].wait()

tsplink.trigger[N].reset()

This function resets some of the TSP-Link trigger attributes to their factory defaults. This function is not available
on the Models 2604B/2614B/2634B.
Type TSP-Link accessible
Function Yes
Usage
tsplink.trigger[N].reset()
N
Details
The tsplink.trigger[N].reset() function resets the following attributes to their factory defaults:
•
tsplink.trigger[N].mode
•
tsplink.trigger[N].stimulus
•
tsplink.trigger[N].pulsewidth
This also clears tsplink.trigger[N].overrun.
Example
tsplink.trigger[3].reset()
Also see
tsplink.trigger[N].mode
tsplink.trigger[N].overrun
tsplink.trigger[N].pulsewidth
tsplink.trigger[N].stimulus
2600BS-901-01 Rev. B / May 2013
(on page 7-356)
(on page 7-356)
(on page 7-358)
(on page 7-359)
(on page 7-360)
(on page 7-362)
(on page 7-364)
Affected by
The trigger line (1 to 3)
(on page 7-358)
(on page 7-359)
(on page 7-360)
(on page 7-362)
Section 7: TSP command reference
Releases trigger line 3.
Where saved Default value
Resets TSP-Link trigger line 3
attributes back to factory default
values.
7-361