Eventlog.overwritemethod; Exit() - Keithley 2601B Reference Manual

Section 7: TSP command reference

eventlog.overwritemethod

This attribute controls how the event log processes events if the event log is full.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
method = eventlog.overwritemethod
eventlog.overwritemethod = method
method
Details
When this attribute is set to eventlog.DISCARD_NEWEST, new entries are not logged.
When this attribute is set to eventlog.DISCARD_OLDEST, the oldest entry is discarded when a new entry is
added.
Example
eventlog.overwritemethod = 0
Also see
eventlog.all() (on page 7-84)
eventlog.clear()
eventlog.count
eventlog.enable
eventlog.next()

exit()

This function stops a script that is presently running.
Type TSP-Link accessible
Function No
Usage
exit()
Details
Terminates script execution when called from a script that is being executed.
This command does not wait for overlapped commands to complete before terminating script execution. If
overlapped commands are required to finish, use the waitcomplete() function before calling exit().
Also see
waitcomplete()
7-88
Affected by
Instrument reset
Recall setup
Set to one of the following values:
•
0 or eventlog.DISCARD_NEWEST: New entries are not logged
•
1 or eventlog.DISCARD_OLDEST: Old entries are deleted as new events are logged
(on page 7-85)
(on page 7-86)
(on page 7-86)
(on page 7-87)
Affected by
(on page 7-380)
Series 2600B System SourceMeter® Instrument Reference Manual
Where saved
Not saved
When the log is full, the event log will ignore
new entries.
Where saved
Default value
1
(eventlog.DISCARD_OLDEST)
Default value
2600BS-901-01 Rev. B / May 2013