Section 7: TSP command reference
Example
data = tsplink.readport()
print(data)
Also see
TSP-Link synchronization lines
tsplink.readbit()
tsplink.writebit()
tsplink.writebit()
tsplink.writeport()
tsplink.reset()
This function initializes (resets) all nodes (instruments) in the TSP-Link system. This function is not available on
the Models 2604B/2614B/2634B.
Type
TSP-Link accessible
Function
No
Usage
nodesFound = tsplink.reset()
nodesFound = tsplink.reset(expectedNodes)
nodesFound
expectedNodes
7-354
(on page 3-90)
(on page 7-353)
(on page 7-364)
tsplink.readbit()
(on page 7-364)
(on page 7-365)
Affected by
The number of nodes actually found on the system
The number of nodes expected on the system (1 to 64)
Series 2600B System SourceMeter® Instrument Reference Manual
Reads state of all three TSP-Link lines.
Assuming line 2 is set high, the output is:
2.000000e+00
(binary 010)
The format of the output may vary depending on the
ASCII precision setting.
(on page 7-353)
Where saved
Default value
2600BS-901-01 Rev. B / May 2013