Smux.trigger.endsweep.action; Smux.trigger.idle_Event_Id - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual

smuX.trigger.endsweep.action

This attribute sets the action of the source at the end of a sweep.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
action = smuX.trigger.endsweep.action
smuX.trigger.endsweep.action = action
action
X
Details
Use this attribute to configure the source action at the end of the sweep. The SMU can be programmed to return
to the idle source level or hold the last value of the sweep.
Example
smua.trigger.endsweep.action =
smua.SOURCE_IDLE
Also see
Triggering

smuX.trigger.IDLE_EVENT_ID

This constant contains the idle event number.
Type TSP-Link accessible
Constant Yes
Usage
eventID = smuX.trigger.IDLE_EVENT_ID
eventID
X
Details
Set the stimulus of any trigger object to the value of this constant to have the trigger object respond to idle events
from this SMU.
2600BS-901-01 Rev. B / May 2013
Affected by
SMU reset
Instrument reset
Recall setup
The source action at the end of a sweep; set to one of the following values:
0 or smuX.SOURCE_IDLE: Sets the source level to the programmed (idle) level at
the end of the sweep
1 or smuX.SOURCE_HOLD: Sets the source level to stay at the level of the last step
Source-measure unit (SMU) channel (for example,
smua.trigger.endsweep.action applies to SMU channel A)
(on page 3-32)
Affected by
The idle event number
Source-measure unit (SMU) channel (for example,
smua.trigger.IDLE_EVENT_ID applies to SMU channel A)
Section 7: TSP command reference
Where saved Default value
Not saved 0 (smuX.SOURCE_IDLE)
Sets SMU channel A to return the source
back to the idle source level at the end of a
sweep.
Where saved Default value
7-239