Smux.measure.highcrangedelayfactor; Smux.measure.interval - Keithley 2601B Reference Manual

Section 7: TSP command reference

smuX.measure.highcrangedelayfactor

This attribute contains a delay multiplier that is only used during range changes when the high-capacitance mode
is active.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
delayFactor = smuX.measure.highcrangedelayfactor
smuX.measure.highcrangedelayfactor = delayFactor
delayFactor
X
Details
This delay multiplier is only active when the high-capacitance mode is active.
Example
smua.measure.highcrangedelayfactor = 5
Also see
High-capacitance mode
reset() (on page 7-160)
setup.recall()
smuX.reset() (on page 7-216)
smuX.source.highc

smuX.measure.interval

This attribute sets the interval between multiple measurements.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
interval = smuX.measure.interval
smuX.measure.interval = interval
interval
X
7-206
Affected by
Instrument reset
SMU reset
Recall setup
The delay factor; set to a value between 1 and 99
SMU channel (for example, smua.measure.highcrangedelayfactor applies
to SMU Channel A)
(on page 3-65)
(on page 7-180)
(on page 7-221)
Affected by
Instrument reset
SMU reset
Recall setup
The interval value (in seconds); set to a value between 0 and 1
Source-measure unit (SMU) channel (for example,
smua.measure.interval applies to SMU channel A)
Series 2600B System SourceMeter® Instrument Reference Manual
Where saved
Saved setup
Increases the delay used during range changes for
SMU channel A by a factor of 5.
Where saved
Saved setup
Default value
10
Default value
0 (0 s)
2600BS-901-01 Rev. B / May 2013