Lan.autoconnect; Lan.config.dns.address[N] - Keithley 2601B Reference Manual

Section 7: TSP command reference
Example
lan.applysettings()
Also see
None

lan.autoconnect

This attribute is used to enable or disable link monitoring.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
state = lan.autoconnect
lan.autoconnect = state
state
Details
This attribute sets the LAN link monitoring and automatic connection state.
When this is set to lan.ENABLE, all connections are closed if the link to the LAN is lost for more than the time
specified by lan.linktimeout.
Set this attribute to lan.ENABLE to automatically reset the LAN connection after the LAN link is established.
Also see
lan.linktimeout
lan.restoredefaults()

lan.config.dns.address[N]

Configures DNS server IP addresses.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
dnsAddress = lan.config.dns.address[N]
lan.config.dns.address[N] = dnsAddress
dnsAddress
N
7-112
Affected by
LAN restore defaults
LAN link monitoring state:
1 or lan.ENABLE: Enables automatic link reconnection and monitoring
0 or lan.DISABLE: Disables automatic link reconnection and monitoring
(on page 7-119)
(on page 7-121)
Affected by
LAN restore defaults
DNS server IP address
Entry index (1 or 2)
Series 2600B System SourceMeter® Instrument Reference Manual
Re-initialize the LAN interface with new settings.
Where saved
Nonvolatile memory
Where saved
Nonvolatile memory
Default value
1 (lan.ENABLE)
Default value
"0.0.0.0"
2600BS-901-01 Rev. B / May 2013