Lan.trigger[N].Mode - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual

lan.trigger[N].mode

This attribute sets the trigger operation and detection mode of the specified LAN event.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
mode = lan.trigger[N].mode
lan.trigger[N].mode = mode
mode
N
Details
This attribute controls the mode in which the trigger event detector and the output trigger generator operate on
the given trigger. These settings are intended to provide behavior similar to the digital I/O triggers.
LAN trigger mode values
Mode
lan.TRIG_EITHER
lan.TRIG_FALLING
lan.TRIG_RISING
lan.TRIG_RISINGA
lan.TRIG_RISINGM
lan.TRIG_SYNCHRONOUS
lan.TRIG_SYNCHRONOUSA
lan.TRIG_SYNCHRONOUSM
lan.TRIG_RISING and lan.TRIG_RISINGA are the same.
lan.TRIG_RISING and lan.TRIG_RISINGM are the same.
Use of either lan.TRIG_SYNCHRONOUSA or lan.TRIG_SYNCHRONOUSM over lan.TRIG_SYNCHRONOUS is
preferred, as lan.TRIG_SYNCHRONOUS is provided for compatibility with older firmware.
Example
print(lan.trigger[1].mode)
Also see
Digital I/O
TSP-Link system expansion interface
2600BS-901-01 Rev. B / May 2013
Affected by
Instrument reset
LAN trigger N reset
Recall setup
A number representing the trigger mode (0 to 7); see the Details section for
more information
A number representing the LAN event number (1 to 8)
Number
0
1
2
3
4
5
6
7
(on page 3-83)
Where saved
Not saved
Trigger packets detected as
input
Rising or falling edge (positive
or negative state)
Falling edge (negative state)
Rising edge (positive state)
Rising edge (positive state)
Rising edge (positive state)
Falling edge (negative state)
Falling edge (negative state)
Rising edge (positive state)
Outputs the present LAN trigger mode of LAN
event 1.
(on page 6-47)
Section 7: TSP command reference
Default value
0 (lan.TRIG_EITHER)
LAN trigger packet
generated for output
with a...
negative state
negative state
positive state
positive state
positive state
positive state
positive state
negative state
7-133