Section 7: TSP command reference
gettimezone()
This function retrieves the local time zone.
Type
TSP-Link accessible
Function
Yes
Usage
timeZone = gettimezone()
timeZone
Details
See settimezone() for additional details about the time zone format and a description of the fields.
timeZone can be in either of the following formats:
•
If one parameter was used with settimezone(), the format used is:
GMThh:mm:ss
•
If four parameters were used with settimezone(), the format used is:
GMThh:mm:ssGMThh:mm:ss,Mmm.w.dw/hh:mm:ss,Mmm.w.dw/hh:mm:ss
Example
timezone = gettimezone()
Also see
settimezone()
gm_isweep()
This KIParlib factory script function performs a linear current sweep and calculates the transconductance (Gm) at
each point.
Type
TSP-Link accessible
Function
No
Usage
gm_array, vbuf, ibuf = gm_isweep(smu, start_i, stop_i, points)
gm_array
vbuf
ibuf
smu
start_i
stop_i
points
7-98
Affected by
The local timezone of the instrument
(on page 7-178)
Affected by
A Lua table containing the calculated Gm values at each point
A reading buffer containing the measured voltage at each point
A reading buffer containing the measured current at each point
System SourceMeter
channel A)
Starting current level of the sweep
Ending current level of the sweep
Number of measurements between start_i and stop_i (must be ≥ 2)
Series 2600B System SourceMeter® Instrument Reference Manual
Where saved
Reads the value of the local timezone.
Where saved
®
instrument channel (for example, smua refers to SMU
Default value
Default value
2600BS-901-01 Rev. B / May 2013