Section 7: TSP command reference
tspnet.tsp.abort()
This function causes the TSP-enabled instrument to stop executing any of the commands that were sent to it.
Type
TSP-Link accessible
Function
No
Usage
tspnet.tsp.abort(connectionID)
connectionID
Details
This function is appropriate only for TSP-enabled instruments.
Sends an abort command to the remote instrument.
Example
tspnet.tsp.abort(testConnection)
Also see
None
tspnet.tsp.abortonconnect
This attribute contains the setting for abort on connect to a TSP-enabled instrument.
Type
TSP-Link accessible
Attribute (RW)
No
Usage
tspnet.tsp.abortonconnect = value
value = tspnet.tsp.abortonconnect
value
7-374
Series 2600B System SourceMeter® Instrument Reference Manual
Affected by
Integer value used as a handle for other tspnet commands
Stops remote instrument execution on testConnection.
Affected by
Instrument reset
Recall setup
1 (enable) or 0 (disable)
Where saved
Default value
Where saved
Not saved
2600BS-901-01 Rev. B / May 2013
Default value
1 (enable)