Commands That Cannot Be Used In Scripts; Manage Scripts - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual

Commands that cannot be used in scripts

Though an instrument accepts the following commands, you cannot use these commands in scripts.
Commands that cannot be used in scripts
General commands
abort
endflash
endscript
flash
loadscript
loadandrunscript
password
restoreglobals

Manage scripts

This section describes how to create scripts by sending commands over the remote interface and
using TSB Embedded.
Tools for managing scripts
To manage scripts, you can send messages to the instrument, use your own development tool or
program, use Keithley Instruments Test Script Builder (TSB) software, or use TSB Embedded on the
instrument's web interface. TSB and TSB Embedded are described below.
•
Test Script Builder (TSB) software: TSB software is a programming tool that is on the Test
Script Builder Software Suite CD-ROM (included with your Series 2600B). You can use it to
create, modify, debug, and store Test Script Processor (TSP
information about using the TSB software, see
•
TSB Embedded: TSB Embedded is a tool with a reduced set of features than the complete
Keithley TSB software. TSB Embedded has both script-building functionality and console
functionality (single-line commands). It is accessed from a web browser.
If you are using TSB or TSB Embedded to create scripts, you do not need to use the commands
loadscript or loadandrunscript and endscript.
Create and load a script
You create scripts by loading them into the run-time environment of the instrument. You can load a
script as a named script or as the anonymous script.
Once a script is loaded into the instrument, you can execute it remotely or from the front panel.
Anonymous scripts
If a script is created with the loadscript or loadandrunscript command with no name defined,
it is called the "anonymous" script. There can only be one anonymous script in the run-time
environment. If another anonymous script is loaded into the run-time environment, it replaces the
existing anonymous script.
2600BS-901-01 Rev. B / May 2013
IEEE Std 488.2 common commands
*CLS *RST
*ESE *SRE
*ESE? *SRE?
*ESR? *STB?
*IDN? *TRG
*OPC *TST?
*OPC? *WAI
Using Test Script Builder (TSB)
Section 6: Instrument programming
®
) scripting engine scripts. For more
(on page 6-31).
6-3