8.3.6
Finisher firmware/Saddle stitcher firmware (MJ-1030)
Important:
•
Be sure to shut down the equipment before installing and removing the download jig.
•
Do not shut down the equipment during the update. The data could be damaged and not be
operated properly.
[A] Firmware update
(1)
Install the ROM to the download jig (K-PWA-DLM-320).
Make sure the direction is correct.
(2)
Press the [ON/OFF] button on the control panel to shut down the equipment.
(3)
Take off the finisher rear cover.
* Connect the finisher interface cable with the equipment after removing the finisher rear cover.
(4)
Connect the download jig with the jig connector on the finisher control PC board.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
FIRMWARE UPDATING
Finisher rear cover
Fig. 8-36
Connector
Fig. 8-37
8 - 46
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved