Saddle Stitcher Firmware (Mj-1104) - Toshiba e-STUDIO6520C Service Handbook

8.3.4

Saddle stitcher firmware (MJ-1104)

Important:
• Be sure to shut down the equipment before installing and removing the download jig.
• Do not shut down the equipment during the update. The data could be damaged and not be
able to be operated properly.
[A] Update Procedure
(1) Install the ROM to the download jig (K-PWA-DLM-320).
Make sure the direction is correct.
(2) Press the [ON/OFF] button on the control panel to shut down the equipment.
(3) Open the front upper cover and then pull out the saddle unit.
(4) Loosen 2 screws and turn the saddle control PC board access cover in the direction of the arrow.
(5) Connect the download jig with the jig connector (CN16) on the Saddle control board.
(6) Press the [ON/OFF] button while simultaneously holding down the [0] and [8] buttons.
Updating starts and the LED on the download jig lights.
e-STUDIO5520C/6520C/6530C
FIRMWARE UPDATING
Saddle control PC board access cover
Fig. 8-35
Download jig
Fig. 8-36
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
8 - 40