Table of Contents
Advertisement
9B-10 Lighting Systems:
Turn Signal and Hazard Warning Relay
Inspection
1) Connect turn signal and hazard warning relay (1),
battery (2) and six test bulbs ((12V, 21W) (3) and 12
V, 5W (4)) as shown.
3
3
2) Check turn L circuit
Connect terminal "5" and battery negative (–)
terminal by a jumper wire.
Check left side bulbs (1) for flashing cycle.
If check result is not as specified, replace turn signal
and hazard warning relay.
Reference flashing cycle
60 – 120 cycle/minute
1
3) Check turn R circuit
Connect terminal "6" and battery negative (–)
terminal by a jumper wire.
Check right side bulbs (1) for flashing cycle.
If check result is not as specified, replace turn signal
and hazard warning relay.
Reference flashing cycle
60 – 120 cycle/minute
1
S7RS0B9206012
1
3
2
1
8
7
6
5
4
4
2
I4RS0A920014-01
3
2
1
8
7
6
5
4
I4RS0A920015-01
3
2
1
8
7
6
5
4
I4RS0A920016-01
4) Check Hazard ON circuit
Connect terminal "8" and battery negative (–)
terminal by a jumper wire.
Check all bulbs (1) for flashing cycle.
If check result is not as specified, replace turn signal
and hazard warning relay.
Reference flashing cycle
60 – 120 cycle/minute
1
1
License Light Removal and Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove rear bumper. Refer to "Front Bumper and
Rear Bumper Components in Section 9K".
3) Disconnect coupler (1) from license light (2).
4) Push locking part to arrow direction, and then
remove license light (2).
2
2
Installation
Reverse removal procedure for installation.
3
2
1
8
7
6
5
4
I4RS0A920017-01
S7RS0B9206013
1
2
I4RS0B920010-01
Hide quick links:
Advertisement
Chapters
Table of Contents
