Outputting Alarms To The Snmp Agent - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Step 2 Configuring the channel through which alarms are output to the VTY terminal
1.
2.
Step 3 Enabling terminal display
1.
2.
----End

5.4.8 Outputting Alarms to the SNMP Agent

By outputting alarms to the SNMP agent, you can view the operating status of the device on the
NMS.
Context
Do as follows on the switch configured with the information center:
Procedure
Step 1 Configuring the alarms to be output through the channel
1.
2.
Step 2 Configuring the channel through which alarms are output to the SNMP agent
1.
2.
Issue 03 (2011-12-29)
Run:
info-center monitor channel { channel-number | channel-name }
The channel through which alarms are output to the VTY terminal is configured.
By default, alarms are output to the VTY terminal through Channel 1.
Run:
quit
Back to the user view.
Run:
terminal monitor
Terminal display is enabled.
Run:
terminal trapping
Displaying alarms on the terminal is enabled.
Run:
system-view
The system view is displayed.
Run:
info-center source { module-name | default } channel { channel-number | channel-
name } [ trap { state { off | on } | level severity }
Alarms are added to the information channel.
By default, the timestamp format of alarms is date.
Run:
info-center snmp channel { channel-number | channel-name }
The channel through which alarms are output to the SNMP agent is configured.
Run:
snmp-agent
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Information Center Configuration
*
]
71