Setting Console Terminal Attributes - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - Basic Configuration
The flow control mode is set. By default, the flow-control mode is none.
Step 5 (Optional) Run:
parity { even | mark | none | odd | space }
The parity mode is set.
By default, the value is none.
Step 6 (Optional) Run:
stopbits { 1.5 | 1 | 2 }
The stop bit is set.
By default, the value is 1 bit.
Step 7 (Optional) Run:
databits { 5 | 6 | 7 | 8 }
The data bit is set.
By default, the data bit is 8.
----End

5.3.3 Setting Console Terminal Attributes

You can configure the timeout period for idle users, maximum number of lines to displayed on
each screenor the maximum number of characters in each line, and the size of historical command
buffer for the console interface.
Context
Do as follows on the switch to which a user logs in:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
user-interface console interface-number
The console interface view is displayed.
Step 3 Run:
shell
The terminal service is started.
Step 4 Run:
idle-timeout minutes [ seconds ]
Issue 01 (2011-07-15)
NOTE
When the user logs in to a switch through a console port, the configured attributes for the console port on
the HyperTerminal should be in accordance with the attributes of the interface on the switch. Otherwise,
the user cannot log in to the switch.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 User Management
61