Chapter 1 Ethernet Port Configuration Commands; Ethernet Port Configuration Commands; Broadcast-Suppression; Description - Huawei quidway s3526 series Getting Started

Command Manual - Port
Quidway S3500 Series Ethernet Switches

Chapter 1 Ethernet Port Configuration Commands

1.1 Ethernet Port Configuration Commands

1.1.1 broadcast-suppression

Syntax
broadcast-suppression { ratio | bandwidth bandwidth }
undo broadcast-suppression
View
Ethernet port view
Parameter
ratio: Specifies the maximum bandwidth ratio of the broadcast traffic allowed on
Ethernet port, ranging form 1 to 100. By default, the value is 100. The smaller the ratio
is, the smaller the broadcast traffic is permitted.
bandwidth: Specifies the maximum bandwidth of the broadcast traffic on Ethernet port.
It ranges from 1 to 100 for 100Mbit/s port in Mbit/s.

Description

Using broadcast-suppression command, you can configure the broadcast traffic size
enabled on port. Once the broadcast traffic exceeds the value set by the user, the
system will discard some broadcast to ensure network service so that the traffic ratio of
broadcast is maintained in a proper range. Using undo broadcast-suppression
command, you can restore the default broadcast traffic enabled on port as 100. i.e.,
100% broadcast traffic is allowed to pass through.
Example
# Enable 20% broadcast cast to pass, i.e. 80% broadcast storm suppression is made
on broadcast traffic of port.
[Quidway-Ethernet0/1] broadcast-suppression 20
1.1.2 description
Syntax
description text
undo description
Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-1