Display Commands; Displaying The Status Of The S9300; Displaying Information About The S9300 - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management

3.1 Display Commands

This section describes the functions of display commands and lists the display commands in
common use.
As an important means to maintain and troubleshoot a network, the display commands can be
used to collect current information about the version, device, and diagnosis of the S9300.
Table 3-1
Terabit Routing Switch - Command Reference.
You are disallowed to run the display diagnostic-information command simultaneously on
multiple terminals connected to the S9300. Otherwise, the CPU usage of the S9300 may
obviously rise and the network performance may be degraded.
Table 3-1 Common display commands
Command
display current-configuration
display device
display version
display this
display diagnostic-information
display this interface

3.2 Displaying the Status of the S9300

This section describes how to use display commands to view the version, CPU, memory, and
voltage of a device.

3.2.1 Displaying Information About the S9300

You can use the display command to view information about S9300 components.
Issue 03 (2011-12-29)
lists the display commands in common use. For details, see the Quidway S9300
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
Displays the parameters that take effect currently on the
S9300.
Displays information about the S9300.
Displays the version and boards information of the
S9300.
Displays valid configurations in the current view.
It is mainly used to collect information about the S9300
when a fault cannot be located or rectified. Then, you can
send the information to Huawei technical personnel for
fault analysis.
NOTE
This command is not recommended for routine troubleshooting.
Displays the current status of the interface.
3 Displaying the Device Status
24