Configuring The Mstp Protocol Packet Format On An Interface - Huawei Quidway S7700 Configuration Manual - Ethernet

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The Ethernet interface view is displayed.
Step 3 (Optional) Run:
stp binding process process-id
The interface is bound to an MSTP process.
Step 4 Run:
stp no-agreement-check
The common rapid transition mechanism is configured.
By default, the interface uses the enhanced rapid transition mechanism.
----End

9.6.3 Configuring the MSTP Protocol Packet Format on an Interface

MSTP protocol packets can be transmitted in auto, dot1s, or legacy mode. The default mode is
auto.
Context
MSTP protocol packets have two formats: dot1s (IEEE 802.1s standard packets) and legacy
(proprietary protocol packets). The auto mode is introduced to allow an interface to automatically
use the format of MSTP protocol packets sent from the remote interface. In this manner, the two
interfaces use the same MSTP protocol packet format.
Do as follows on a switching device in an MST region:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The Ethernet interface view is displayed.
Step 3 (Optional) Run:
stp binding process process-id
Issue 01 (2011-07-15)
NOTE
This step binds an interface to an MSTP process with a non-zero ID. If the interface belongs to process 0,
skip this step.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 MSTP Configuration
456