Optional) Setting The Timeout Interval For Receiving Lacp Packets; Checking The Configuration - Huawei AR3200 Series Configuration Manual - Lan

Enterprise routers
Hide thumbs Also See for AR3200 Series:
Table of Contents

Advertisement

Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN
1.4.10 (Optional) Setting the Timeout Interval for Receiving LACP
Packets
Context
Perform the following steps on the AR3200 to set the timeout interval for receiving LACP
packets.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Step 3 Run:
lacp timeout { fast | slow }
The timeout interval for receiving LACP protocol packets is set on the Eth-Trunk.
----End

1.4.11 Checking the Configuration

Procedure
l
l
----End
Example
Run the display trunkmembership eth-trunk command to view the operation mode, total
number of member interfaces, number of member interfaces in Up state, and information about
member interfaces of an Eth-Trunk.
Issue 02 (2012-03-30)
NOTE
l After the lacp timeout command is configured, the local end informs the peer end of the configured
timeout interval through LACP packets. The peer end then sends LACP packets at the specified interval.
If the fast keyword is used, the peer end sends LACP packets at an interval of 1 second. If the slow
keyword is used, the peer end sends LACP packets at an interval of 30 seconds.
l The timeout interval for receiving LACP packets on the local end is three times the interval at which
the peer end sends LACP packets. That is, when the fast keyword is used, the timeout interval for
receiving LACP packets is 3s; when the slow keyword is used, the timeout interval for receiving LACP
packets is 90s.
l You can select different keywords on the two ends. However, it is recommended that you select the
same keyword on both ends to facilitate maintenance.
Run the display trunkmembership eth-trunk trunk-id command to display the member
interfaces of the Eth-Trunk.
Run the display eth-trunk [ trunk-id [interface interface-type interface-number ] ]
command to display information about the Eth-Trunk and member interfaces.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Link Aggregation Configuration
18

Advertisement

Table of Contents
loading

Table of Contents