Ip Prefix List Commands; Clear Ip Prefix-List - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Usage Information When you use the log option, the CP processor logs detail the packets that match.

Depending on how many packets match the log entry and at what rate, the CP may

become busy as it has to log these packet details.

By default, 10 ACL logs are generated if you do not specify the threshold explicitly. The

default frequency at which ACL logs are generated is five minutes. By default, flow-

based monitoring is not enabled.

Use the monitor option only when you are using flow-based monitoring. For more

information, refer to the Port Monitoring chapter of the C9000 Series Configuration

IP Prefix List Commands

When you create an access-list without any rule and then apply it to an interface, the ACL behavior reflects

implicit permit.

To configure or enable IP prefix lists, use these commands.

Reset the number of times traffic meets the conditions ("hit" counters) of the configured prefix lists.

C9000 Series

clear ip prefix-list [prefix-name]

Clears "hit" counters for all prefix lists unless a prefix list is specified.

Command Modes

EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms, refer

to the relevant Dell Networking OS Command Line Reference Guide.

When ACL logging and byte counters are configured simultaneously, byte

counters may display an incorrect value. Configure packet counters with logging

— configures a filter to drop packets.

— configures a filter to forward packets.

(OPTIONAL) Enter the name of the configured prefix list to clear

only counters for that prefix list, up to 140 characters long.

Access Control Lists (ACL)

Table of Contents