Ip Ftp Source-Interface - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Usage Information The password is listed in the configuration file; you can view the password by entering

the show running-config ftp command.

Use the ip ftp password command when you use the ftp: parameter in the

copy command.

ip ftp username

ip ftp source-interface

Configure an interface's IP address as the source IP address for FTP connections.

C9000 Series

ip ftp source-interface interface

To delete an interface, use the no ip ftp source-interface interface

Introduced on the S4810.

Introduced on the Z9000.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Introduced on the C-Series.

Original command.

— sets the user name for the FTP sessions.

Enter the following keywords and slot/port or number

information:

For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16383.

For a Port Channel interface, enter the keyword port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Control and Monitoring

Table of Contents