Clear Ets Counters - Dell C9000 Series Reference Manual

Version
9.9(0.0)
9.6(0.0)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.16.0
Usage Information When you apply an ETS output policy to on interface, ETS-configured scheduling and
bandwidth allocation take precedence over any configured settings in QoS output
policies.
When you disable DCB, ETS is disabled by default. When you enable DCB, ETS is
enabled for all interfaces that have the default ETS configuration applied (all dot1p
priorities in the same group with equal bandwidth allocation).
Related dcb-map— to configure PFC and ETS on Ethernet ports that support converged
Commands Ethernet traffic.

clear ets counters

Clear all ETS TLV counters on an interface.
C9000 Series
Syntax
clear ets counters port-type slot/port
Parameters
port-type
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.7(0.1)
9.7(0.0)
Description
Introduced on the C9010.
Removed from the S-series. Replaced by the dcb-map
commands.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the keywords port-type then the slot/port information.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Data Center Bridging (DCB) 699