Mep Cross-Check Start-Delay; Ping Ethernet - Dell Force10 S4810P Reference Manual

mep cross-check start-delay

Configure the amount of time the system waits for a remote MEP to come up before the cross-check operation is
started.
S-Series, S4810
Syntax mep cross-check start-delay number
Parameters
start-delay
number
Defaults 3 ccms
Command Modes ETHERNET CFM
Command History
Version 8.3.7.0
Version 8.3.1.0

ping ethernet

Send a loopback message.
S-Series, S4810
Syntax ping ethernet domain [name l level] ma-name ma-name remote
{dest-mep-id | mac-addr mac-address} source {src-mep-id | port
interface}
Parameters
name | level
ma-name
name
dest-mep-id
mac-addr
address
src-mep-id
port
Defaults none
Command Modes EXEC Privilege
208
Enter a start-delay in seconds. The range is 3 to 100 seconds.
Introduced on the S4810.
Introduced on the S-Series.
Enter the domain name or level.
ma-
Enter the keyword ma-name and then enter the maintenance
association name.
Enter the MEP ID that is the target of the ping.
mac-
Enter the keyword mac-addr and then enter the MAC address that
is the target of the ping.
Enter the MEP ID that originates the ping.
interface
Enter the keyword port and then enter the interface that originates
the ping.