Relation With Other Functions - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (2/2)
13 Spindle Control
13.13 Spindle Oscillation

13.13.3 Relation with Other Functions

The following table lists the restrictions on synchronous operation when other function commands are output during execution
of spindle oscillation or when the spindle oscillation command is output during the execution of other functions.
○ : Command output allowed △ : Command output allowed with restrictions ×: Command output not allowed (error
generation) -: Exclusive spindle oscillation control not allowed
Name of Function
Coil switch
Automatic coil switch
Encoder input I/F
Spindle rotation command (forward/reverse) △ (*3)
S code output
Constant surface speed control
Spindle override
Multiple-spindle control I
Multiple-spindle Control II
Spindle orientation
Spindle position control (spindle/C axis con-
trol)
Spindle synchronization I
Spindle synchronization II
Guide bushing spindle synchronization
Tool spindle synchronization IA (spindle-
spindle and polygon)
Tool spindle synchronization IB (spindle-
spindle and polygon)
Tool spindle synchronization IC (spindle-NC
axis and polygon)
Tool spindle synchronization II (hobbing)
Spindle speed clamp
Thread cutting (lead/thread number designa-
tion)
Variable lead thread cutting
Synchronous tapping cycle
Pecking tapping cycle
Deep-hole tapping cycle
High-speed synchronous tapping
Tapping retract
NC reset
Emergency stop
Command allowed/not allowed
Spindle oscilla- Function exe-
tion (*1) cuting (*2)
×
○
- -
- -
△ (*4)
△ (*5) △ (*6)
△ (*5) △ (*6)
△ (*5) △ (*6)
○ ○
× ×
× ×
× ×
× ×
× ×
× ×
× ×
× ×
△ (*5) △ (*6)
- -
- -
× ×
× ×
× ×
× ×
- × (*7)
△ (*8) ○
-
○
553
Remarks
The spindle oscillation command is
not allowed when spindle specifica-
tion parameter #3074 GBsp is set to
any value other than "0".
IB-1501668-B