Mitsubishi Electric M800VW Series Programming Manual page 825

Plc programming

Hide thumbs Also See for M800VW Series:

Table of Contents

M800V/M80V Series PLC Programming Manual (2/2)

14 PLC Help Function

14.33 PLC Axis Control

 PLC axis control buffering mode information address

The PLC axis control buffering mode information address stores head R registers of the buffering mode control information for

each PLC axis. (Note 1)

PLC axis control buffering

mode information address

(1) The following R registers can be used.

R8300 to R9799 (Area backed up by battery)

R9800 to R9899 (Area not backed up by battery)

R18300 to R19799 (Area backed up by battery)

R19800 to R19899 (Area not backed up by battery)

R28300 to R29799 (Area backed up by battery)

R29800 to R29899 (Area not backed up by battery)

(2) If the setting value of R register is out of range or odd number, the target PLC axis turns invalid.

(3) In the following explanations, the R register Nos. stored in the PLC axis control buffering mode information address are

indicated with Rn. The PLC axis control information data arrangement follows the arrangement of "R1n" and others,

which is referred in "(3) PLC axis control information address".

 PLC axis control information data

The control information data is stored in the R register value indicated by the PLC axis control information address and the

subsequent register values before starting the PLC axis control process. The control information data arrangement is shown

Alarm details

Control signal

Axis specification (*1)

Operation mode

Movement data

Machine position

Remaining distance

(*1) Axis specification is valid only for buffering mode.

IB-1501668-B

Common for all axes

PLC axis No.

Show Quick Links

Table of Contents