Mitsubishi Electric M800VW Series Programming Manual page 622

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.8 High-Speed Simple Program Check
[Timing chart example]
Alarms are generated during part system 2
High-speed simple
program check mode
(Y73E)
High-speed simple
program check mode ON
(X712)
Automatic operation "start"
(ST): $1/$2
Processing program: $1
(No difference between start
time/finish time position)
Processing program: $2
(Start time/finish time positions
are different)
NC reset: $1
(NRST1,NRST2,RRW)
NC reset: $2
(NRST1,NRST2,RRW)
High-speed simple program
checkEnable coordinate
position check (Y76B)
"High-speed simple program
checkCoordinate position
check ON (X713)"
Alarm: $2
Axis check settings
The axes to which the coordinate position check are applied are specified by the axis parameters within user parameters.
Axes are specified by turning the parameter ON (1) for axes you want to check and turning the parameter OFF (0) for axes
you do not want to check.
 Workpiece coordinate position: "#8226 Wk position check"
 Machine coordinate position: "#8227 Machine posn check"
G0X100. ･･･ M02
G0Z50. ･･･ M02
601
G0X100. ･･･
While the alarm is
sounding, automatic
operation of all part
G0Z50. ･･･
systems cannot be
started. After the alarm is stopped,
automatic operation of all
part systems can be
Alarm 1215
IB-1501668-B