Operation Explanation - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.5 Reservation of Tool Wear Compensation (Lathe System)

14.5.2 Operation Explanation

(1) When the reserved tool wear compensation memory has never been initialized after setting "#8140 Reserve T wear com"
to "1", the contents of the tool wear compensation memory is copied to the reserved tool wear compensation memory and
initialized.
(2) The reserved tool wear compensation memory is reflected to the tool wear compensation memory when either of the fol-
lowing operations is performed.
 Turned ON the power again.
 Turned ON the "Reservation of tool wear compensation" signal (YD0F).
(*1) To copy again the contents of the tool wear compensation memory to the reserved tool wear compensation memory
after the initialization of (1), reset "#8140 Reserve T wear com" to "0" and turn ON the power again. Then set "#8140
Reserve T wear com" to "1", and turn ON the power again.
<Setting reserved tool wear compensation memory>
Item
Reserved tool nose wear compensation amount
for 1st axis
Reserved tool nose wear compensation amount
for 2nd axis
Reserved tool wear compensation amount for
additional axis
Reserved tool nose radius wear compensation
amount
Reserved tool wear compensation amount for
2nd additional axis
Reserved tool wear compensation memory can be set only from the custom API.
Reserved tool wear compensation amount can be read or write by designating section No., sub-section No. and part
system No.
Note
(1) When "#1051 MemTol" (Tool compensation memory common for part systems) is set to "1", a part system cannot be
specified.
IB-1501668-B
Reserved tool wear
compensation
memory
(1)
(2)
(*1)
Tool wear
compensation
memory
Section No. Sub-section No.
14 13000 + compensation No.
14 14000 + compensation No.
14 15000 + compensation No.
14 16000 + compensation No.
14 17000 + compensation No.
590