Plc -> Nc Interface Signal - Mitsubishi Electric M800VW Series Programming Manual

Plc programming

Hide thumbs Also See for M800VW Series:

Table of Contents

M800V/M80V Series PLC Programming Manual (2/2)

14 PLC Help Function

14.36 External Search

14.36.2 PLC -> NC Interface Signal

External search device No.

External search program No.

External search sequence No.

External search block No.

External search strobe

 External search device No.

The device storing the machining program to be searched is designated with a No.

When a front SD card is selected in M800VS/M80V Series, select either "2" or "4" for the device number.

When a rear SD card is selected in M800VS/M80V Series, select "1" for the device number.

When a front USB port of the display unit is selected, select "6" for the device number.

HD operation with industrial personal computer (IPC) connection can be specified only for M80V Series.

To enable HD operation with industrial personal computer, the following parameter settings are required.

 Set "#1760 cfgPR10/bit2" (Enable HD mode on IPC) to "1"

 IP address of industrial personal computer to connect to "#11005 PC IP address" (IP address setting)

Display unit-side high-speed program server

Memory card , front SD card

Control unit-side high-speed program server

Tape (RS232C)

Front USB port of display unit

HD for industrial personal computer (D: \NCFILE)

Extended area (Memory 2)

 Program No.

Designate the No. of the machining program to be searched as a binary. 0 to 99999999 (8 digits)

 Sequence No.

Designate the sequence No. of the machining program to be searched as a binary. 0 to 99999999 (8 digits)

Designate the block No. as a binary. 0 to 999999999 (9 digits)

Part system No.

IB-1501668-B

Show Quick Links

Table of Contents