Mitsubishi Electric M800VW Series Programming Manual page 647

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.12 Chopping
PLC -> NC interface signals
Contact Signal name
A CHOPPING
[Function]
This signal validates the chopping function.
[Operation]
The chopping mode is entered at the rising edge of this signal.
Contact Signal name
A CHOPPING PARAMETER VALID
[Function]
This signal validates the chopping control data assigned to R register.
[Operation]
 The chopping mode is entered at the rising edge of this signal.
 This signal must be turned OFF after confirming the chopping start ready completion signal is turned ON.
"Chopping start ready completion" signal is included in the control status within the chopping control data.
Contact Signal name
CHOPPING COMPENSATION UPDATE
A
PREVENTION REQUEST
[Function][Operation]
This signal prevents the chopping compensation amount from being updated.
[Related signals]
(1) Chopping compensation update prevented (CHPRCC: XC7F)
IB-1501668-B
Signal abbre-
$1 $2
viation
CHPS YC30 YD70
Signal abbre-
$1 $2
viation
YC34 YD74
Signal abbre-
$1 $2
viation
CHPRCR YCD7 YE17
626
$3 $4
YEB0 YFF0
$3 $4
YEB4 YFF4
$3 $4
YF57 Y1097