M800V/M80V Series PLC Programming Manual (1/2)
9 Exclusive Instructions
9.1 ATC Exclusive Instruction
9.1.11 Precautions for Using ATC Exclusive Instructions
When tool data is rewritten by ATC or other than ATC instruction, tool registration screen display is not updated. The following
processing is required:
Turn ON special relay SM64 by using the SET instruction.
[Program example]
ACT
PLS M10
M10
SET SM64
SM64 processing is not required for ATC instructions ATC K5, K6 (forward run, reverse run of pointer), ATC K7, K8 (for-
ward run, reverse run of tool table).
SM64 is set through the use of the user PLC and reset by controller.
445
IB-1501667-B