Operation When A Tool Has Reached The End Of Its Tool Life - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.16 Tool Life Management (Lathe System)

14.16.2 Operation When a Tool Has Reached the End of Its Tool Life

When the cumulative cutting hours has reached estimated tool life (hours) or when the cumulative number of cuttings has
reached estimated number of cuttings, the "Tool life over" signal (XC2E) turns ON by the T command which is issued after the
said situation.
For the tool life management I, when the tool which has not reached the end of its tool life yet, the "Tool life over" signal
(XC2E) turns OFF.
For the tool life management II, when the status of all the tools, which are registered in the arbitrary group, become "Normal
life tool", the "Tool group life over" signal (XC2F) turns ON.
IB-1501668-B 654