Mitsubishi Electric M800VW Series Programming Manual page 465

M800V/M80V Series PLC Programming Manual (1/2)
9 Exclusive Instructions
9.1 ATC Exclusive Instruction
Automatic tool data write
All tool Nos. are written (entered) in batch. This instruction is used for initialization, etc.
The data are written one after another for each tool, starting from the default value.
ACT
S.ATC K11 R9800 R10610 M10
R9800 9840
R9801
R9840 1000
R10615 2
R10700 1008(0)
R10701 1009(1)
R10702 1000(2)
: 1001(3)
: 1002(4)
: 1003(5)
: 1004(6)
: 1005(7)
R10708 1006(8)
R10709 1007(9)
Note
(1) When pointer is not used, R10615 should be set to "zero".
(Example)
MOV K0 R10615
IB-1501667-B
R No. where default value is stored
Default value
Pointer
Tool data table head
Tool data of the number of tools are written while
incrementing the default value one by one from the
spot indicated by the pointer.
444