Mitsubishi Electric M800VW Series Programming Manual page 650

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.12 Chopping
 In manual mode
In the jog and step mode, when the chopping axis is not moving, the chopping operation is started at the rising edge of the
"Chopping" signal.
If the "Chopping" signal is turned ON when the chopping axis is moving, the OPERATION ALARM 0154 will occur, and the
chopping will not be started.
(Rising edge of the "Chopping" signal is ignored.)
[When the chopping axis is not moving]
Chopping parameter valid
Chopping start ready completion
Chopping (CHPS)
In chopping mode (CHPMD)
In chopping start (CHOP)
Chopping axis
[When the chopping axis is moving]
Chopping parameter valid
Chopping start ready completion
Chopping (CHPS)
In chopping mode (CHPMD)
In chopping start (CHOP)
Chopping axis
In the handle mode, when the chopping axis is not selected for the handle axis, the chopping operation is started at the rising
edge of the "Chopping" signal.
If the "Chopping" signal is turned ON when the chopping axis is selected for the handle axis, the OPERATION ALARM 0154
will occur, and the chopping will not be started.
(2)
(3)
(1)
Operation alarm 0154
629 IB-1501668-B