Machine Input/Output Signal Allocation By Cc-Link; File Register By Cc-Link - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (2/2)
16 External PLC link
16.1 CC-Link
Note
(1) When installing two FCU8-EX561, these cannot be used as master stations at a time.
(2) Refer to "CC-Link Specifications manual" (BNP-C3072-089) on parameter setting.
(3) When connecting NC with GX Developer as a slave station, set it as the intelligent device station.

16.1.2.1 Machine Input/Output Signal Allocation by CC-Link

Input/output device allocation when CC-Link module is mounted is as shown below.
RIO only
RIO1 RIO2
X00 X100
Input : :
XFF X1FF
Y00 Y100
Output : :
YFF Y1FF
Note
(1) When using CC-Link communication, do not duplicate the devices used by actual RIO.

16.1.2.2 File Register by CC-Link

Device
R8300 to R9799
R18300 to R19799 User backup area
R28300 to R29799
R9800 to R9899
R19800 to R19899 User work area
R29800 to R29899
IB-1501668-B
With CC-Link communication
RIO3 RIO1 RIO2 RIO3
X200 X00 X100 X200
: : :
X2FF XFF X1FF X2FF
Y200 Y00 Y100 Y200
: : :
Y2FF YFF Y1FF Y2FF
Description
CC-Link communication
X0
: :
X5FF
Y0
: :
Y5FF
912