Position Display Counter - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.27 3-Dimensional Manual Feed

14.27.7 Position Display Counter

Position display counter indicates as follows during the 3-dimensional manual feed.
 Tool axis travel amount
This counter indicates the tool's travel amount in the tool axis coordinate system.
Note, however, that this counter is not updated in one of the following cases.
 When a selected hypothetical coordinate system is not tool axis coordinate system
 When the manual absolute is ON
Selected coordinate
Manual absolute
ON
Tool axis coordinate
OFF
 Table coordinate system counter
This counter indicates the position in the table coordinate system.
Note, however, that this counter is not updated while the manual absolute is OFF.
Selected coordinate
Manual absolute
Tool axis coordinate
ON
OFF
 Inclined surface counter
This counter indicates the position in the feature coordinate system.
While the inclined surface machining command is disabled, a position in the workpiece coordinate system is displayed
instead.
Note, however, that this counter is not updated while the manual absolute is OFF.
Inclined surface ma-
Manual absolute
chining command
ON
OFF
IB-1501668-B
Tool axis travel amount
system
- Not updated
A travel amount in the tool axis coordinate sys-
system tem is displayed
Others Not update
Table coordinate system counter
system
A position in the table coordinate system is dis-
system
played.
Others
- Not updated
Selected coordinate
system
Feature coordinate
system
ON
Others
Feature coordinate
system
OFF
Others
- -
Feature coordinate system counter
A position in the feature coordinate system is
displayed.
A position in the workpiece coordinate system is
displayed.
Not updated
746