Selected Coordinate System Output - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.27 3-Dimensional Manual Feed

14.27.8.2 Selected Coordinate System Output

For each manual mode and handle to use, this signal is used to inform of the hypothetical coordinate system in which the 3-
dimensional manual feed is carried out.
Con-
Signal name
tact
Tool axis coordinate system in 3-dimen-
A
sional manual feed (JOG,INC)
Table coordinate system in 3-dimensional
A
manual feed (JOG,INC)
Feature coordinate system in 3-dimen-
A
sional manual feed (JOG,INC)
[Function]
This signal indicates the coordinate system in which the 3-dimensional manual feed is carried out by the jog or incremental
feed.
When this signal is ON, jog feed or incremental feed is carried out in the coordinate system of the signal.
[Operation]
This signal turns ON when:
 The hypothetical coordinate system for the 3-dimensional manual feed (JOG, INC) has been selected during jog feed or
incremental feed.
This signal turns OFF when:
 The hypothetical coordinate selection for the 3-dimensional manual feed (JOG, INC) is turned OFF.
 The jog feed or incremental feed mode is turned OFF.
[Related signals]
(1) In jog mode (JO:XC00)
(2) In incremental mode (SO:XC02)
(3) 3-dimensional manual feed (JOG, INC) in tool axis coordinate system
(4) 3-dimensional manual feed (JOG, INC) in table coordinate system
(5) 3-dimensional manual feed (JOG, INC) in feature coordinate system
(6) In tool center point rotation (TCPRS:XD27)
IB-1501668-B
Signal ab-
$1 $2
breviation
MJST XD18 XE58
MJSB XD19 XE59
MJSF XD1A XE5A
750
$3 $4 $5 $6
XF98 X10D8 X1218 X1358
XF99 X10D9 X1219 X1359
XF9A X10DA X121A X135A
$7 $8
X1498 X15D8
X1499 X15D9
X149A X15DA