Tool Data Flow (R Register) - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.15 Tool Life Management (Machining Center System)

14.15.2 Tool Data Flow (R register)

Tool life management registers contain the spare tool data (R11800 to R11823) and the active tool data (R11824 to R11847).
The tool data specified by a T command is output to the data area for spare tool.
The tool data corresponding to the spindle tool No. is output to the data area for active tool.
Tool Data Flow (R register)
T command
R536, R537
Data area for spare tool
R11800, R11801
R11802, R11803
R11804
R11805
R11806, R11807
R11808, R11809
The NC searches for the
R11810
tool data specified by the
R11811
T command.
R11816, R11817
Searched tool data is set
R11818, R11819
in R11800 to R11823.
R11820, R11821
R11822, R11823
The data is used for
R12200, R12201
the tool life
management and
Data area for active tool
the screen display.
R11824, R11825
R11826, R11827
R11828
R11829
The tool data
R11830, R11831
corresponding to the
R11832, R11833
spindle tool No. is
output. R11834
R11835
R11840, R11841
R11842, R11843
R11844, R11845
R11846, R11847
NC
T command data
Group No.
Tool No.
Tool data flag/Status (Note 1)
Auxiliary data (depending on the MTB specifications)
Cumulative cutting hours (Management by cutting hours) (Note 2)
Estimated tool life (hours) (Management by cutting hours) (Note 3)
Cumulative number of cuttings (Management by number of cuttings)
Estimated number of cuttings (Management by number of cuttings)
Tool length compensation data (Note 4)
Tool radius compensation data (Note 4)
Tool length wear data (Note 4)
Tool radius wear data (Note 4)
Spindle tool No.
Group No.
Tool No.
Tool data flag/Status (Note 1)
Auxiliary data (depending on the MTB specifications)
Cumulative cutting hours (Management by cutting hours) (Note 2)
Estimated tool life (hours) (Management by cutting hours) (Note 3)
Cumulative number of cuttings (Management by number of cuttings)
Estimated number of cuttings (Management by number of cuttings)
Tool length compensation data (Note 4)
Tool radius compensation data (Note 4)
Tool length wear data (Note 4)
Tool radius wear data (Note 4)
647
PLC
Status check, etc.
When a T command is issued, a
magazine is indexed using the tool
No. set in R11802, R11803. When a
tool is mounted on the spindle, set the
tool No. in R12200, R12201.
Status check, etc.
IB-1501668-B