Manual Numerical Value Command - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function

14.9 Manual Numerical Value Command

14.9 Manual Numerical Value Command
For each S, M, T, G and B command, the data type to output to PLC program is designated by parameters "#12006 Mbin" (M
binary), "#12008 Sbin" (S binary), "#12010 Tbin" (T binary) and "#12012 Bbin" (B binary).
The output data type and the manual numerical value command setting/output range are shown below.
S -99999999 to 99999999 (*1)
M
0 to 99999999
Output range
T
B
S -99999999 to 99999999 (*2)
M
Setting range
T
B
(*1) Even if the parameter "#12008 Sbin" (S binary) is set to "0" (BCD), the signed binary output is applied to S. BCD output
is not applied.
(*2) If a negative value is set when the data type is "BCD type" or "Unsigned binary type", a value converted into positive
value is output to PLC program.
Add a "-" sign before the value to set a negative value. The display will be a positive value.
A value larger than the limit rotation speed (parameters "#3001 slimt1" to "#3004 slimt4") or the maximum rotation speed
(parameters "#3005 smax1" to "#3008 smax4") cannot be output for S. Select a gear with "Spindle gear selection input" of Y
device.
For details on flow of S data, refer to "13.3 Flow of Spindle (S) Data".
For details on storage destination of manual numerical commands and process sequence, refer to "12 Handling of M, S, T, B
Functions".
BCD Unsigned binary
0 to 99999999
603
Signed binary
-99999999 to 99999999
IB-1501668-B