Mitsubishi Electric M800VW Series Programming Manual page 754

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.26 Simple Inclined Surface Machining Command
 Counter display during manual feed
[Inclined surface coordinate position counter]
The inclined surface coordinate position counter indicates a machine position relative to the feature coordinate system.
While inclined surface control command is OFF, the counter indicates a machine position relative to the work coordinate
system.
However, while the manual absolute switch signal is OFF, the counter is not updated.
Manual absolute Inclined surface ma-
switch signal chining command
ON
OFF
[Manual interruption amount counter]
While Simple inclined surface control command is active, the manual interruption amount counter indicates a manual
interruption relative to the feature coordinate system.
While Simple inclined surface control command is OFF, the counter indicates a manual interruption relative to the machine
coordinate system.
However, while the manual absolute switch signal is ON, the counter is not updated.
Manual absolute Inclined surface ma-
switch signal chining command
ON
OFF
Handle interrupt function in automatic operation mode during simple inclined surface machining
When setting the parameter "#1284 ext20/bit6 (Automatic operation handle interruption during inclined surface machining)" to
"1", the automatic operation handle interruption can be used.
When handle interrupt in automatic operation mode is executed, make sure to turn OFF the manual ABS switch.
When handle interrupt in automatic operation mode is executed in the following cases, the alarm (M01 0185) occurs:
 When the parameter "#1145 I_abs (Manual ABS parameter)" is set to "0" and the manual ABS switch is turned ON
 When the parameter "#1061 intabs (Manual ABS updating)" is set to "1" for any of the axes of the part system while the
parameter "#1145 I_abs (Manual ABS parameter)" is set to "1"
Selected coordinate system
Feature coordinate system
ON
Other than feature coordinate system
Feature coordinate system
OFF
Other than feature coordinate system
ON/OFF
Selected coordinate system
ON/OFF
ON
OFF Machine coordinate system
Inclined surface coordinate position
Indicates a machine position with re-
spect to the feature coordinate system
Indicates a machine position with re-
spect to the work coordinate system
- Not updated
Manual interruption amount counter
- Not updated
Indicates an interruption amount rela-
-
tive to the feature coordinate system
Indicates an interruption amount rela-
tive to the machine coordinate system
733
counter
IB-1501668-B