Mitsubishi Electric M800VW Series Programming Manual page 768

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.27 3-Dimensional Manual Feed
 Manual interruption amount
While the inclined surface machining command is enabled, this counter indicates a manual interruption amount in the feature
coordinate system.
If a hypothetical coordinate system is being selected while the inclined surface machining command is disabled, a position in
the selected hypothetical coordinate system is displayed.
If a hypothetical coordinate system is not selected while the inclined surface machining command is disabled, a position in the
machine coordinate system is displayed.
Note, however, that this counter is not updated while the manual absolute is ON.
Inclined surface ma-
Manual absolute
chining command
ON
OFF
Selected coordinate
system
- -
ON -
Selected
OFF
Not selected
Manual interruption amount
Not updated
An interruption amount in the feature coordinate
system is displayed.
An interruption amount in the selected coordi-
nate system is displayed.
An interruption amount in the machine coordi-
nate system is displayed.
747 IB-1501668-B