Examples Of Tool Registration Screen - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (1/2)
9 Exclusive Instructions
9.1 ATC Exclusive Instruction

9.1.12 Examples of Tool Registration Screen

Tool registration screen examples are given below. For operation, refer to the instruction manual.
 Comment display area
The display at the comment display area is created using the message creation function explained in the "Peripheral
Development Environment".
 Spindle tool, standby tool display area
The number of display items can be changed according to the control parameter value.
The number of the standby tools is specified with the control parameter (R10600).
To display two or more standby tools, set the parameter "#11054 Sp-stby disp type" to "1".
Control parameter (R10600)
F E D C B A 9
00: Only spindle tool is displayed.
01: Spindle tool and standby 1 are displayed.
02: Spindle tool and standby 1 and 2 are displayed.
03: Spindle tool and standby 1 to 3 are displayed.
04: Spindle tool and standby 1 to 4 are displayed.
05 or more: No spindle tool or standby tool is displayed.
Hexadecimal expression
 Magazine tool No. display area
The number of displayed magazine tools and the magazine No. start value can be changed according to the number-of-
magazine parameter and control parameter values.
[Number of magazines]
Number-of-magazine parameter (R10610): Setting range
0 to 120: When not arbitrary setting the tools
0 to 360: When arbitrary setting the tools
Note
(1) If "0" is set, the magazine tool is not displayed. However, the magazine No. and magazine tool number guide area is dis-
played.
IB-1501667-B
8 7 6 5 4 3 2 1
Comment display area
Spindle, standby tool No.
display area
Magazine tool No.
display area
0
446